Product Manual
3. The detergent should only leave an acceptable amount of
residue on the parts. For new parts in particular, you may need
a detergent that is “free rinsing”.
4. To be used in a jet washer, the detergent needs to be “low
foaming”.
To insure the satisfaction of our customers, KleenTec has developed its’ own line
of detergents and additives.
IV. START-UP PROCEDURE
CAUTION Do not start this procedure until you have read this manual in its’
entirety.
CAUTION Do not fill the tank or start this procedure unless you can spend the 3-
4 hours necessary to heat the water, add detergent, and run the wash
cycle for at least 2 hours. Otherwise, rusting may occur.
CAUTION Before turning on the electrical power, make sure the heat switch and
wash timer are off. If the heating elements go on when the tank is
empty, they will promptly burn out.
When using your jet washer for the first time, follow the steps below:
1. Make sure the electrical power to the machine is off.
2. Verify that your electrician checked the rotation of all motors.
3. Make sure the heat switch and wash timer is off.
4. Fill the wash tack so that the water depth is 11” (1” below the
top edge of the filter basket.)
5. Turn on electrical power to the machine.
6. Set the thermostat between 150-180F (see
“CONTROLS/OPERATION”)
7