Product Manual
Your jet washer automatically cleans parts by spraying them with a hot, detergent and
water solution that is recirculated. The operator loads parts into the basket, shuts the
door (lid), and starts the cleaning cycle. During the cleaning cycle, the parts basket
rotates through spray curtains, which are created by, spray nozzles located above,
below, and outside the turntable. The force of the spray jets, in combination with the
heat and the chemical action of the detergent will remove contaminants within minutes.
Generally, any contaminant that can be removed, will be removed within 15 minutes.
THE HEATING SYSTEM/WATER LEVEL
The wash solution is recirculated from a holding tank, which forms the base of
the jet washer. The capacity of the rank is 65 gallons. The correct water depth is
11”.
The holding tank is heated with electric heating elements that are controlled by a
toggle switch adjustable thermostat. The thermostat is located on the right side,
close to the floor. The black adjustment knob is mounted next to the heating
element cover.
Most customers set the temperature between 140 and 160F. Below 140F,
many detergents will foam (consult you detergent supplier.) Above 180F, your
pump may cavitate, resulting in lower pressure and poorer cleaning results.
To turn the heating elements on and off, the Jet Washer has the standard toggle
switch. Allow 3-1/2 hours for a 100 - 110F temperature rise.
3