Product Manual
I. PRECAUTIONS/DANGERS
Read this entire manual before attempting to install your KleenTec jet washer. You will
be less likely to make mistakes if you have a grasp of the “whole” picture.
DANGER
1. Your machine uses HIGH VOLTAGE electricity. Obtain the services of a qualified
electrician for all electric work.
2. Do not use any petroleum base chemical or solvent, or any flammable products in
your jet washer.
3. The heating element (s) will be ruined and the pump/motor may get damaged if
they are turned on when the holding tank is empty or has a low water level. Check
the water level at least daily.
4. Cleaning will be poor and the heating element (s) and pump/motor may get
damaged if the machine is not cleaned according to instructions.
5. Your jet washer is made with mild steel and will rust unless you use the correct
detergent and follow the correct start-up procedure. If you are not using a
KleenTec detergent, make sure the brand you are using is safe on mild steel and
has an adequate concentration of rust inhibitors. When installing the unit, don’t fill
the tank with water unless you have the time needed to heat the water to 150-
170F, add the detergent, and run the wash cycle for at least two (2) hours to cat
the steel with rust inhibitor. Again, read this entire manual before starting the
installation so that you know what is involved. (see “chemical Selection”)
6. Since laws and regulations are forever changing, and since they often vary region
to region, the remarks in this section should only be construed as a general
guideline. It is your responsibility to research, understand, and follow the exact
environmental regulations of your region.
Protect your environment and protect your business from fines by handling your
dirty cleaning solution according to federal, state, and local codes. According to
federal regulations, which states have to adopt as minimum standards, the dirty
1