Product Manual

wirewheel away from the turntable rim by loosening the spring tension. Pull the

turntable straight up until its’ shaft comes out of the bearing assembly.

3. Remove the front screen.

4. Pump the water (we recommended an air operated diaphragm pump) into one or

more drums. As stated earlier in this manual, you can normally re-use this water

many times before disposal is required.

5. Scrape the sludge out of the tank and handle it according to governing

regulations.

6. Pump the water content back into the tank or fill the tank with fresh water so the

water depth is 11”.

7. If you have a problem with clogged spray holes, you may need to flush out the

spray pipes.

Remove any pipe caps. Run a brief 30 to 60 second – wash cycle to flush out the

sediment. (CAUTION: Running a longer wash cycle could damage the pump

motor.)

8. Replace the turntable and tighten the compression spring on the gear motor.

9. Adjust the detergent concentration, and replace the cover plates.

MONTHY

1. Check all external hoses for leaks or weaknesses and replace if necessary.

Check these hoses during a wash cycle to see if a bubble forms in the hose

lining.

QUARTERLY

1. Check the drive wheel for wear and replace if necessary.