User Guide
Conference Mate
Note: Improper use will invalidate the guarantee! In some countries
there may be restrictions to the use of Bluetooth® devices. Check the
regulations in your area.
CARE AND MAINTENANCE
Read the following recommendations before using Conference Mate™
and you can enjoy your new product for many years.
1. Keep it dry and don’t take it to damp places to avoid aecting the
unit’s internal circuitry.
2. Keep the product away from direct sunlight and extreme heat.
High temperatures will shorten the life of electronic devices,
destroy the battery, or distort certain plastic parts.
3. Don’t expose the product to extreme cold. It may damage the
internal circuit board.
4. Don’t try to disassemble the product; it contains no user
replaceable parts and will void the warranty.
5. Don’t let it fall to the floor or other hard surfaces. The internal
circuitry may get damaged.
6. Don’t use harsh chemical products or detergent to clean .
7. Don’t scratch the surface with anything sharp.
CHARGING THE BATTERY
1. Connect the micro USB cable end to the micro USB charging port on
Conference Mate™.
2. Connect the standard USB plug end of the cable to the power
adapter that came with Conference Mate™ or the USB port on a
computer or other USB charging device.
3. A red LED will be on while the unit is charging and turn o when
the unit is fully charged.
Note: The red LED will flash when the battery is low. If you turn o
the unit while it is charging it will charge faster. It normally takes
about 5 hours to fully charge Conference Mate™ if you use a your
computer’s USB port.
POWERING ON AND OFF
The ON/OFF switch has 3 positions:
To left: Power OFF.
To middle: Power ON. Conference Mate™ will connect with the most
recently paired device.
To right: Enter pairing mode.
4
5
Care and Maintenance