Owner's manual

Workshop Manual for
AUTOPRIME Q Range Pump Unit
Manual No/Rev
W72-021E / 8
Our policy is one of continuous improvement and we reserve the right to alter specifications at any time
Page 33 of 36
9.11 Spark Arrestor – 3CE1
ITEM
DESCRIPTION
PART No
QTY
Spark Arrestor Assembly: 24341 1
1 Spark Arrestor 25017 1
2 Support 21334 2
3 Bolt M8 x 25 Self Lock 18165 4
4 Nut M8 Self Lock 18173 4
5 Inlet Pipe 25018 1
Chalwin Valve Assembly: 24342 1
6 Pipe Clamp 25288 1
7 Chalwin Valve 21168 1
8 Stud M10 x 65 21815-318-347-7 1
9 Nut M10 Self Locking 18174 1
9.12 Spark Arrestor – 4LE1 & 4LE2
ITEM
DESCRIPTION
PART No
QTY
Spark Arrestor Assembly: 21312 1
1 Spark Arrestor 25017 1
2 Support 21334 2
3 Bolt M8 x 25 Self Lock 18165 4
4 Nut M8 Self Lock 18173 4
5 Inlet Pipe 25019 1
Chalwin Valve Assembly: 21313 1
Chalwin Valve D40BS 21168 1
6 Hose Clip 25742-212-000-3 1
9.13 Hose Fittings
Autoprime Q range pumps are supplied as
standard fitted with Bauer hose connections but if
damaged or lost the following parts will be
required.
ITEM DESCRIPTION PART No
QT
Y
1 Stud M16 x 35 21815-461-347-6 12
2 Nut M16 Self Locking 18176 12
For QI 100 Pumps
3 4” BS10D 45Deg Female 16394 1
4 4” BS10D 45Deg Male 19102 1
For QI 150 Pumps
5 6” BS10D 45Deg Female 13693 1
6 6” BS10D 45Deg Male 19103 1
For QI 200 Pumps
7 8” BS10D 60Deg Female 14536 1
8 8” BS10D 60Deg Male 14537 1
Based on 21946, 21927 and 21947 as on 11-09-05
10. INSPECTION & TESTING
Note: If the unit has received a major overhaul, do
all the checks listed on the Pre Delivery
Inspection (PDI) form.
If some parts have been disassembled, do
the checks relating to the parts that have
been worked on.
Check the engine coolant and oil levels and
the pump seal oil level before starting the
engine.
Confirm that the battery is fully charged and
the fluid levels are correct.
Confirm that the fuel tanks contain sufficient
fuel for the testing.
Where new drive belts have been fitted,
check and adjust the drive belt tension after
the engine has been run for an hour.
Pre Delivery Test Procedure
Following major overhaul or maintenance
work it is advisable to check and test the unit
as outlined in the Build, Test and Pre-
Delivery Check Sheet on page 32.
Before towing check:
Wheel nuts to ensure tightness.
Tyre pressures and tyre condition.
Towing hitch condition and security.
Brake adjustment.
Trailer draw bar fasteners.
Axle fasteners.
Lifter and lifter stay fasteners
Engine to pump & chassis fasteners.