Owner's manual

Manual No/Rev
W72-021E / 8
Workshop Manual for
AUTOPRIME Q Range Pump Units
Our policy is one of continuous improvement and we reserve the right to alter specifications at any time
Page 28 of 36
7.14.4 Canopy Parts List
ITEM DESCRIPTION PART No. QTY
1
Canopy Assembly Complete 21418 1
2
Canopy Roof Support 21823 1
3 Bolt M 8 X 16 Flange Self Lock 18163 6
4 Door Control Panel Autoprime 15462 1
5 Hinge Offset “A” 96-50-510-50 15460 1
6 Hinge Offset “B” 96-50-520-50 15461 1
7 Socket Screw Cap M 5 X 10 21835-068-347-7 8
8 Control Panel Door Seal 16899 1
9 Control Panel Door Spacer 16969 1
10 Vise Action Door Latch 13775 1
11 Plastic Plug M16 Yellow 18338 4
12 Insulation Hanger for 25mm 14431 5
13 Sound Insulation Kit 23594 1
14
Door Assembly Pair Yellow 21924 1
15 Left Hand Yellow Door 14349 1
16 Right Hand Yellow Door 14350 1
17 Gas Strut Hinge Bracket 13733 2
18 Door Hinge Nylon Spacer 6mm 14125 4
19 Bolt M 8 X 16 Flange Self Lock 18163 8
20 Door Lock Plate 13734 2
21 Nut M6 Self Locking Flanged 18172 8
22 Vise Action Door Latch 13775 2
23 Gas Spring 700n 13781 2
24 Washer M8 Nylon SY9509700 8
25 Socket Screw Cap M 8 X 40 21835-142-347-8 2
26 Washer M 8 21172-210-342-8 2
27 Nut Hex M8 – Nyloc 21882-672-347-6 2
28 Spacer 14430 4
29 Clip Retaining Clevis 89001 13941 2
30 Clevis Pin 5/16”Dia X 1.5”Long 13940 2
31 Hinge Pin Canopy Door Nylon 13921 4
32 Louver Panel 16410 1
33 Stud M8 x 25 21816-257-962-6 3
34 Louver Tray 21537 1
35 Nut M8 self Locking 18173 5
36 Washer Nylon 18205 5
37 Front Panel 21671 1
38 Bolt M8 x 16 Self Locking 18163 6
39 Foam Strip 13920 1
40 Noise Reducing Baffle 13744 1
41 Bolt M 6 X 10 Flange Self Lock 18162 2
42 Bolt M 8 X 16 Flange Self Lock 18163 6
43 Cover QI 100 21690 1
44 Cover QI 150 21691 1
44 Cover QI 150M 26450 1
45 Cover QI 200 21692 1
46 Radiator Panel 21672 1
47 Bolt M8 x 16 Self Locking 18163 2
48 Nut M8 self Locking 18173 2
49 Washer Nylon 18205 4
50
Radiator Panel Extension
21673 1
51 Bolt M6 x 10 Self Locking 18162 4
52 Nut M6 self Locking 18172 4
53 Radiator Duct Seal Strip 13920 1
ITEM DESCRIPTION PART No. QTY
54 Duct – Air Outlet 21586 1
55 Gasket Rear Air Duct 21687 1
56 Bolt M10 x 40 Self Locking 18167 2
57 Nut M10 Self Locking 18174 2
58 Washer Nylon 18205 4
59 Bolt M8 x 16 Self Locking 18163 2
60 Nut M8 Self Locking 18173 2
61 Tube Plastic 8 ID x 1.5 wall 12501 6
62 Cable Base TY 14
63 Cable Tie 100 x 2.5mm TY1000 14
64 Lifter Cover 21686 1
65 Strip Extruded Side Balloon 21587 7.5M
7.15 Control Panel & Electrical Wiring
7.15.1 Additional Electrical Parts
ITEM DESCRIPTION PART No QTY
1
Screw Hex M10 x 20 21863-174-347-0 2
2
Insulating Boot 08797 1
3
Retainer 16385 4
4
Wear Cup 16386 4
5
Stud 16387 4
6
Bolt M6 x 10 Self Lock 18162 2
7
Nut M6 Self Locking 18172 3
8
Screw Tap 3.5 x 9.5 18211 2
9
Plate for Loom Mtg. 18228-221 1
10
Conduit Clip 25 mm 18293 5
11
Screw Hex M6 x 12 21863-100-347-7 5
7.15.2 Wiring Loom & Control Panel Fitting.
1. Pass the control panel end of the loom
through the canopy support frame at the
rear of the control panel housing and fit the
loom mounting plate (9) to the canopy
support frame as shown:
2. Fit loom support clips (10) to the canopy
support frame, baffle and lifter as shown:
3. Connect to engine and priming system as
per the required wiring diagram.