HYDRAFLOW HYDRAULIC SUBMERSIBLE PUMPS OPERATORS INSTRUCTIONS S4T Pump Pump Weight 74 Kg SPP Pumps Limited Crucible Close Mushet Industrial Park Coleford Gloucestershire GL16 8PS Telephone: ++44(0)1594 832 701 Fax: ++44(0)1594 836 300 Document No: Revision No: Revision Note No: W79-008E 4 Windchill Date Issued.
DECLARATION OF CONFORMITY We SPP Pumps Limited Of Crucible Close Mushet Industrial Park Coleford Gloucestershire GL16 8PS Declare that: HYDRAULIC DRIVE SUBMERSIBLE PUMP HYDRAFLOW S4T As shown on the Pump Nameplate Equipment: Model/Type: Serial Number: In accordance with the following Directive: 2006/42/EC Machinery Directive have been designed and manufactured to the following specifications: EN 809:1998+A1:2009 Pumps and Pump Units for Liquids - Safety Requirements EN 12100:2003 Parts 1 and 2 -
Operators Instructions for HYDRAFLOW S4T Hydraulic Submersible Pump Manual No/Rev W79-008E / 4 CONTENTS 1. INTRODUCTION 4 1.1 1.2 1.3 Power Unit Hydraulic Hoses Submersible Pumps 4 5 5 2. SAFETY PRECAUTIONS 5 2.1 2.2 Safety Symbols Submersible Pump Safety Precautions 5 5 3. TRANSPORT & STORAGE 6 3.1 3.2 Transport Storage 6 6 4. SERIAL NUMBER 6 5. OPERATING INSTRUCTIONS 6 5.1 5.2 Pump Installation Operation 6 6 6. PUMP MAINTENANCE 6 6.1 6.1.1 6.1.2 6.2 6.3 6.4 6.
Operators Instructions for HYDRAFLOW S4T Hydraulic Submersible Pump Manual No/Rev W79-008E / 4 1. INTRODUCTION The purpose of this handbook is to lay down operating guidelines and routine maintenance for the HYDRAFLOW S4T hydraulic drive submersible pump. circuit will cause damage to the unit and will void the warranty! The pump Is capable of a wide range of applications as it is not subject to normal suction lift limitations.
Operators Instructions for HYDRAFLOW S4T Hydraulic Submersible Pump hoses are fitted incorrectly, damage or danger may result. If you are not sure if the hydraulic power source being used to drive this pump is properly sized or connected, call SPP Pumps Limited. The hoses are supplied with quick release couplings that must be correctly fitted before starting the pump. Due to these selfsealing couplings, the hoses will remain filled with oil when not in use.
Manual No/Rev W79-008E / 4 Operators Instructions for HYDRAFLOW S4T Hydraulic Submersible Pump 2. Check the type of liquid being pumped before working on the pump. Residues could be hazardous to your health. If in doubt flush out with clean water before work commences. 3. Personnel working on the pump unit must always wear clean correctly fitting clothing and safety footwear.
Operators Instructions for HYDRAFLOW S4T Hydraulic Submersible Pump hydraulic oils of viscosity below 150SSU @ 38°C (100°F) or equivalent specification. Note: When using vegetable (Rape Seed) based bio-degradable oil it is important to check the condition of the oil frequently as it tends to breakdown more quickly than the more expensive mineral or synthetic biodegradable oils.
Manual No/Rev W79-008E / 4 Operators Instructions for HYDRAFLOW S4T Hydraulic Submersible Pump WATER although volumes. 13. Check lower ring seal (#14) and replace if necessary. 14. To remove shaft and bearing assembly, remove internal snap ring (#13) and press shaft assembly out of bearing housing. 15. Visually check bearings (#8 and #12). If replacement is necessary, use adequate bearing puller or press. Do NOT use heat to remove bearings. 6.
Operators Instructions for HYDRAFLOW S4T Hydraulic Submersible Pump Manual No/Rev W79-008E / 4 7.
Manual No/Rev W79-008E / 4 Operators Instructions for HYDRAFLOW S4T Hydraulic Submersible Pump 8. PUMP SECTION DRAWING AND PARTS LIST 8.
Operators Instructions for HYDRAFLOW S4T Hydraulic Submersible Pump Manual No/Rev W79-008E / 4 8.2 Parts List Always mention serial # when ordering parts Item Part # Description 1 HT0802174 Quick disconnect hose coupling, female 2. HT0802175 Quick disconnect hose coupling, male 3. HT4002276 Hydraulic Hose Assy. (12" length)(2 req.) 4. HT4002279 Lifting Bracket 5. HT4002152B Hydraulic Motor (Geartek) 6. HT0001549 Hex Nut (4 required) 6a. HT0000163 Lock Washer (4 required) 6b. HT4001550 Stud (4 required) 7.
Manual No/Rev W79-008E / 4 Operators Instructions for HYDRAFLOW S4T Hydraulic Submersible Pump 9. SPARES & SERVICE SPP Pumps operate a comprehensive Spares and Service support network throughout the world, and can be contacted as follows: SPARES & SERVICE Telephone: For spare parts, supply only. ask for - For breakdowns, spare parts and on-site fitting, pump installation and commissioning, and service contracts. ask for For breakdowns outside office hours.
