HYDRAFLOW HYDRAULIC SUBMERSIBLE PUMPS OPERATORS INSTRUCTIONS HYDRAFLOW SUBMERSIBLE PUMP S2TC-2 Pump Weight 7.
DECLARATION OF CONFORMITY We SPP Pumps Limited Of Crucible Close Mushet Industrial Park Coleford Gloucestershire GL16 8PS Declare that: HYDRAULIC DRIVE SUBMERSIBLE PUMP S2TC-2 As shown on the Pump Nameplate Equipment: Model/Type: Serial Number: In accordance with the following Directive: 2006/42/EC Machinery Directive have been designed and manufactured to the following specifications: EN 809:1998+A1:2009 Pumps and Pump Units for Liquids - Safety Requirements EN 12100:2003 Parts 1 and 2 - Safety
Manual No/Rev W79-006E / 4 Operators Instructions for HYDRAFLOW S2TC-2 Hydraulic Submersible Pump CONTENTS 1. INTRODUCTION 4 1.1 1.2 1.3 Power Unit Hydraulic Hoses Submersible Pumps 4 5 5 2. SAFETY PRECAUTIONS 5 2.1 2.2 Safety Symbols Submersible Pump Safety Precautions 5 5 3. TRANSPORT & STORAGE 6 3.1 3.2 Transport Storage 6 6 4. SERIAL NUMBER 6 5. OPERATING INSTRUCTIONS 6 5.1 5.2 Pump Installation Operation 6 6 6. PUMP MAINTENANCE 6 6.1 6.1.1 6.1.2 6.2 6.3 6.4 6.
Manual No/Rev W79-006E / 4 Operators Instructions for HYDRAFLOW S6TC Hydraulic Submersible Pump 1. INTRODUCTION circuit will cause damage to the unit and will void the warranty! The purpose of this handbook is to lay down operating guidelines and routine maintenance for the HYDRAFLOW S2TC-2 hydraulic drive submersible pump. The pump Is capable of a wide range of applications as it is not subject to normal suction lift limitations.
Manual No/Rev W79-006E / 4 Operators Instructions for HYDRAFLOW S2TC-2 Hydraulic Submersible Pump If you are not sure if the hydraulic power source being used to drive this pump is properly sized or connected, call SPP Pumps Limited. The hoses are supplied with quick release couplings that must be correctly fitted before starting the pump. Due to these selfsealing couplings, the hoses will remain filled with oil when not in use. The power unit should be located as near to the pump location as possible.
Manual No/Rev W79-006E / 4 2.3.2 2.3.3 Operators Instructions for HYDRAFLOW S6TC Hydraulic Submersible Pump Check the type of liquid being pumped before working on the pump. Residues could be hazardous to your health. If in doubt flush out with clean water before work commences. 5.1.4 Personnel working on the pump unit must always wear clean correctly fitting clothing and safety footwear.
Manual No/Rev W79-006E / 4 Operators Instructions for HYDRAFLOW S2TC-2 Hydraulic Submersible Pump hydraulic oils of viscosity below 150SSU @ 38°C (100°F) or equivalent specification. Note: When using vegetable (Rape Seed) based bio-degradable oil it is important to check the condition of the oil frequently as it tends to breakdown more quickly than the more expensive mineral or synthetic biodegradable oils.
Manual No/Rev W79-006E / 4 6.5 Operators Instructions for HYDRAFLOW S2TC-2 Hydraulic Submersible Pump can cause seal failure in the hydraulic motor. The system must be open centre at all times (return flow from the submersible pump motor must be allowed to flow freely to the system oil reservoir). Do not use hydraulic directional valves that block the return flow when in the centre position of the valve.
Manual No/Rev W79-006E / 4 Operators Instructions for HYDRAFLOW S2TC-2 Hydraulic Submersible Pump 8. PUMP SECTION DRAWING AND PARTS LIST 8.
Manual No/Rev W79-006E / 4 Operators Instructions for HYDRAFLOW S2TC-2 Hydraulic Submersible Pump 8.2 Parts List Always mention serial # when ordering parts Item Part # Description 1 HT0807320 Male Quick Disconnect Coupler 2. HT3802002 Handle 3. HT0807378 Female Quick Disconnect Coupler 4. HT0209571 Hex Nipple (2 req.) 5. HT0209323 Elbow (2 req.) 6. HT0002009 Hex Bolt SS (6 req.) 7. HT0002011 Lockwasher SS (6 req.) 8. HT3802000 Hydraulic Motor 9. HT3809311 Mechanical Seal Assembly 10.
Operators Instructions for HYDRAFLOW S2TC-2 Hydraulic Submersible Pump Manual No/Rev W79-006E / 4 Our policy is one of continuous improvement and we reserve the right to alter specifications at any time Page 11 of 12
Manual No/Rev W79-006E / 4 Operators Instructions for HYDRAFLOW S2TC-2 Hydraulic Submersible Pump 9. SPARES & SERVICE SPP Pumps operate a comprehensive Spares and Service support network throughout the world, and can be contacted as follows: SPARES & SERVICE Telephone: For spare parts, supply only. ask for - For breakdowns, spare parts and on-site fitting, pump installation and commissioning, and service contracts. ask for For breakdowns outside office hours.
