User's Manual

INSTALLATION
10
Mounting the Network Access Unit
Mount the Network Access Unit only after the optimal location for the unit has been determined (see
“Choosing a location for the Network Access Unit”). The ZEN system ships with basic hardware for
mounting the Network Access Unit to an inside or outside wall.
Flush mounting the Network Access Unit to an inside wall
To mount the Network Access Unit flush to an inside wall.
1. Fasten two screws to the wall, 5½ inches
vertically apart.
Leave approximately a ¼ inch gap between
the head of the screws and the wall.
2. Align the Network Access Unit’s two keyholes
over the screws and slide the unit down until it
snaps into place.
For easy drywall installation, you can locate where
the drywall anchors need to be placed by pressing
the Network Access Unit against the drywall. Tiny
marks will be left in the wall and the screws or
drywall anchors should be installed between these
marks.