User's Manual

INSTALLATION
12
Edge Mounting the Network Access Unit (indoor or outdoor)
The Network Access Unit can be
edge mounted to the inside of a
window frame or to a wall when the
unit needs to be aimed to receive a
stronger signal.
To edge mount the Network
Access Unit
1. Mount the edge bracket to the wall through the keyholes.
If mounting to cement or concrete, first use the bracket as a
template to mark and drill the holes for the concrete screws.
2. Back-off the screws to the point where the edge bracket can just
slide off the wall and then remove the bracket from the wall.
3. Fasten the edge bracket the
Network Access Unit.
4. Align the Network Access
Unit/Bracket assembly keyholes
over the two wall screws and slide
down into place.