User's Manual

INSTALLATION
11
Flush mounting the Network Access Unit to an outside wall
To mount the Network Access Unit flush to an outside wall
1. Fasten the angle bracket to the side of the
Network Access Unit using the two
provided screws.
2. Back-off the side screws to the point
where the bracket can easily slide off the
unit through the keyholes of the bracket.
3. Slide the angle bracket off the Network
Access Unit.
4. Mount the bracket to the wall using
the appropriate screws.
If mounting to cement or concrete,
first use the bracket as a template to
mark and drill the holes for the
concrete screws.
5. Slide the Network Access Unit back into the
keyhole slots on the bracket and tighten the
two screws