User's Manual

Digital Repeater User Manual
- 19 -
7.6.3 Accessories selection
Please pay attention to the two points of “frequency” and “impedance” during the selection of the accessories.
All accessories shall support the repeater’s frequencies from feeder line, antenna and splitter to combiners etc.
For example, the repeater’s frequency is CDMA850, so all the accessories must support the CDMA850
frequency. And the repeater’s impedance is 50ohm, so the accessories shall all be 50ohm. To use any other
impedance of coax will put an extra load on your repeater, shorten its life span and decrease the system
performance.
7.7 Repeater Settings
Please check very carefully all cable connections are correct and firm before running operation test and then
carry out following tests
7.7.1 Switch on power
After power is on, check firstly the RUN LEDs.
 Status and definition of RUN indicators:
Connect the Server Antenna
Connect the Donor Antenna