User's Manual

Digital Repeater User Manual
- 17 -
7.6 Repeater Installation
Installation Steps
Installation block diagram
Installation procedure:
1) According to dimension of bracket, drill 4 *M10 holes on the wall, assembly 4 pieces expansion screws.
2) Put the rack onto the 4 expansion screws, to fix it on the wall with nuts.
3) The repeater hang along the hole on mounting bracket, then install eight hex screws through the holes
from mounting bracket and fixing nut rod of host, tightening screws and fix the host onto the mounting
bracket.
4) Ensure the firm and correct installation.
7.6.2 Repeater’s ports description
1) DC IN: input port to connect with power supply.
2) Power SW: the switcher to turn on or off the repeater
3) Status LEDs: show the working status of repeater
4) ETHERNET port: connected with PC for control and monitoring.
5) USB port: connect USB cable to operate OMT
6) SIM Card Slot: inserted SIM card for remote monitoring
7) Antenna: transfer wireless signal of monitoring information