Quick Install Guide

ManualsBrandsSpotwave Wireless ManualsElectronicsSpotcell 612

Table Of Contents

SpotCell 612 Adaptive Repeater

Quick Installation Guide

www.spotwave.com

Spotwave Wireless Inc. 1 Hines Road, Ottawa ON K2K 3C7 Canada

780-00011-01-02

Spotwave and SpotCell are trademarks of Spotwave Wireless Inc. Patents pending.

Parts List

• Mounting kit

• RG-11 Cables

• High Power Coverage Unit (HPCU)

• Adaptive Repeater Unit (ARU)

(outward-facing unit)

HPCU

(coverage unit)

• Donor Unit (DU)

• Battery

Battery

ARU

mounting

bracket

Customer Provided Material

Typical SpotCell 612 Deployment

ARU

120 feet

20 to 30 feet

IMPORTANT

DU & HPCU

mounting

brackets

bag of

hardware

RG-11

Cable

If required, more detailed information on installing the SpotCell 612 system can

be found in the User Manual. The User Manual is available for downloading at:

www.spotwave.com/2003/support/

The AC power connection for the SpotCell 612 system

must be completed by a licensed electrician in full

accordance with electrical code requirements. All work

on electrical utility poles must be done only by those

trained for such work.

Parts or material that is not included

but which is required to install the

SpotCell 612 system are:

l 110-V AC electrical hook-up for

ARU,

l Ground bonding material for

grounding the ARU, DU and

HPCU (cable, ground rods, etc.),

l DU and HPCU support poles,

l ARU support pedestal (if needed),

l Material such as steel bands for

attaching to non-wooden supports

,or where fastening with screws is

not permitted.

Good physical separation between the DU and HPCU,

combined with back-to-back positioning of the DU and

HPCU units will optimize the coverage area.

HPCU

Coverage Area

10 feet

30 feet

ARU mounts on stub pole

or HPCU support pole.

40-ft HPCU Cable - Included

DU Cable - Order from Spotwave

Summary of content (2 pages)

PAGE 1
TM SpotCell 612 Adaptive Repeater Quick Installation Guide If required, more detailed information on installing the SpotCellTM 612 system can be found in the User Manual. The User Manual is available for downloading at: www.spotwave.com/2003/support/ IMPORTANT The AC power connection for the SpotCell 612 system must be completed by a licensed electrician in full accordance with electrical code requirements. All work on electrical utility poles must be done only by those trained for such work.
PAGE 2
WARNING 1. Install ARU bracket Mount the ARU bracket on a support at least 25-ft from the planned HPCU location. Attach the bracket with either the provided screws or alternatively with steel bands. For your safety beware of overhead power lines and underground power and gas lines, and motor vehicle traffic. Failure to maintain a safe distance from power lines or contact with gas lines could result in death or serious injury. Ensure that all appropriate safety measures are practiced at all times. 2.