User's Manual
Table Of Contents
- Technical Support
- Important Safety Information
- LIMITED WARRANTY AND LIMITATION OF LIABILITY:
- 1 - Introduction
- 2 - Getting Started
- 3 - Installation
- 4 - Mounting the DU and CU
- 5 - Display Information
- 6 - Trouble-Shooting
- Appendix A - SpotCell 100 System Specifications
- Appendix B - SpotCell 111/112 System Specifications
- Appendix C - SpotCell 163 System Specifications
- Appendix D - SpotCell 167 System Specifications
- Appendix E - SpotCell 141/142 System Specifications
- Appendix F - Safety Hints
INSTALLATION
8 SpotCell® 100 Series
d) Use the remaining RG6 cable to connect the PCS DU to the Cell DU.
Figure 3.2: Connecting SC141/142 PCS DU to Cell DU
For all other (non dual band) systems:
a) Connect the DU and CU with the enclosed cable.
Figure 3.3: Connecting CU to DU
3.
Tighten all cable connections to the DUs and CU with a wrench (a 1/4 of a turn
tighter than finger tight) to ensure moisture does not penetrate.
4. Connect the power supply as shown below.
Figure 3.4: Connecting power supply to CU