User's Manual
Table Of Contents
- Technical Support
- Important Safety Information
- LIMITED WARRANTY AND LIMITATION OF LIABILITY:
- 1 - Introduction
- 2 - Getting Started
- 3 - Installation
- 4 - Mounting the DU and CU
- 5 - Display Information
- 6 - Trouble-Shooting
- Appendix A - SpotCell 100 System Specifications
- Appendix B - SpotCell 111/112 System Specifications
- Appendix C - SpotCell 163 System Specifications
- Appendix D - SpotCell 167 System Specifications
- Appendix E - SpotCell 141/142 System Specifications
- Appendix F - Safety Hints
INTRODUCTION
2 SpotCell® 100 Series
Figure 1.1: Base station signal does not reach wireless subscriber
Figure 1.2: SpotCell improves wireless communications
The SpotCellâ„¢ 100 Series adaptive coverage system provides band-selective, on-
frequency, in-building coverage in the cellular, PCS or SMR bands. It uses proprietary,
patent-pending, adaptive techniques that allow a SpotCell solution to be installed and
operated without engineering intervention or support.
The SpotCell solution is generally format specific - AMPS, CDMA/1xRTT/1xEVDO,
TDMA/GSM/GPRS/EDGE, and iDEN formats. When ordering a SpotCell solution be
sure to specify the format, frequency band and sub-band. For PCS band equipment it is
helpful if the start and stop frequencies for the operational sub-band are provided.