User's Manual
Table Of Contents
- 1 – Introduction
- 2 – Getting Started
- 3 – Installation
- 4 – Mounting the DU
- 5 – Display Information
- 6 – Trouble Shooting Information
- Appendix A – SpotCell 100 System Specifications
- Appendix B – SpotCell 111 System Specifications
- Appendix C – SpotCell 112 System Specifications
- Appendix A – Safety Hints
MOUNTING THE DU
22 SpotCell
Mounting the CU
1. Find a suitable location to mount the unit that will provide good
signal coverage. Refer to section 3.3“Choosing a location for the
SpotCell CU”.
2. If mounting on a solid wood surface, or stud covered by drywall,
drill a 1/8th inch diameter hole and mount with #6 x 1.5” screws.
or
If mounting in drywall, drill a ¼ inch diameter hole, insert the
nylon screw anchor, and then mount with a 1/2” pan head screw.
3. Attach cables to the wall using tie wraps and mount directly to the
wall where possible (using 1/2 inch pan head screws). If an anchor is
required drill a 3/16 inch diameter hole, insert the anchor, and
fasten with 1/2 inch screws.