User's Manual
Table Of Contents
- 1 – Introduction
- 2 – Getting Started
- 3 – Installation
- 4 – Mounting the DU
- 5 – Display Information
- 6 – Trouble Shooting Information
- Appendix A – SpotCell 100 System Specifications
- Appendix B – SpotCell 111 System Specifications
- Appendix C – SpotCell 112 System Specifications
- Appendix A – Safety Hints
Spotwave Wireless Inc. 9
3.2.1 Installing the DU
Three methods of positioning the DU (based on location) are outlined
in the following procedure. Specifically they refer to installing inside
buildings, on external walls, and on rooftops.
1. Position the DU (but do not mount it) as close to the final desired
mounting location as possible. The CU does not have to be in its
final location while positioning the DU and it is helpful to have the
CU near the DU.
2. Connect the DU and CU with the enclosed cable. Tighten the cable
to the DU and CU with a wrench (a 1/4 of a turn tighter than
finger tight) to ensure moisture does not penetrate.
3. Connect the power supply as shown below.
Figure 3.1: Connecting power supply to CU
Indoors Roof External wall
While not strictly
required, it is highly
recommended the DU be
installed facing a window
when installed indoors.
The CU does not have to be in its
final position at this time, but it
should not be brought outdoors.