User's Manual
Table Of Contents
- 1 – Introduction
- 2 – Getting Started
- 3 – Installation
- 4 – Mounting
- 5 – Display Information
- 6 – Trouble Shooting Information
- Appendix A – SpotCell 100 System Specifications
- Appendix B – SpotCell 111 System Specifications
- Appendix C – SpotCell 112 System Specifications
- Appendix D – Safety Hints
Spotwave Wireless Inc.
21
4.4 DU indoor mounting
To mount the DU indoors:
1.
Use the mounting bracket as a template and mark the hole
locations. Mark the two regular holes if no motion is required and
mark the hole and the slot if motion is required.
2.
If the mounting is in a solid wood surface, or a stud covered by
drywall, drill a 5/32 inch diameter hole. Mount the unit with 2 inch
wood screws.
or
If the mounting is in drywall, drill a ¼ diameter hole and insert an
anchor. Mount the unit with 1/2 inch pan head screws.
3.
Attach cables to the wall using tie wraps and mount directly to the
wall where possible (using 1/2 inch pan head screws). If an anchor is
required drill a 3/16 inch diameter hole, insert the anchor, and
fasten with 1/2 inch pan head screws.
4.5 Mounting the CU
The CU has a bracket attached as illustrated below. The bracket can be
rotated to allow mounting to a ceiling or wall such that the face of the
unit is parallel to the floor or ceiling, or positioned at approximately 45
degrees.
Figure 4.8: CU mounting bracket.
CU bracket