User's Manual
Table Of Contents
- 1 – Introduction
- 2 – Getting Started
- 3 – Installation
- 4 – Mounting
- 5 – Display Information
- 6 – Trouble Shooting Information
- Appendix A – SpotCell 100 System Specifications
- Appendix B – SpotCell 111 System Specifications
- Appendix C – SpotCell 112 System Specifications
- Appendix D – Safety Hints
M
OUNTING
20
SpotCell
To attach the cable to a brick or concrete wall:
1.
Drill a 3/16 diameter x 1 1/4 inch deep hole using a masonry drill
bit.
2.
Insert the anchor flush with the mounting surface.
3.
Use cable clamps and screws to attach cable to the wall.
4.3.5 Bringing the cable indoors
To bring the cable indoors, it may be necessary to drill a hole through
the wall.
To bring the cable through an exterior wall:
1.
Depending on the material the wall is made of use a wood or
masonry drill bit to drill a 5/8 inch diameter hole.
2.
Pass the connector and cable through the wall.
3.
Use the putty/sealant provided to fill the hole.
4.3.6 Grounding:
Ensure there is a connection to earth ground. Use an appropriate
conductor connected from the stud on the DU to earth ground.
Figure 4.7: DU ground stud
Warning! Failure to properly ground the DU will leave the unit
vulnerable to damage from lightning strikes. Check local building code
requirements for lightning protection and comply with local regulations.
ground
stud