User's Manual

Technical Support
The SpotCell
TM
serial number must be available to authorize technical
support and/or to establish a return authorization for defective units.
The serial number is located on the back of the Coverage Unit (CU) and
Donor Unit (DU) as well as the box in which they were delivered.
Additional support information may be obtained by accessing the
SpotwaveWireless Inc. website at www.spotwave.com. To contact
support by telephone, call your local Spotwave vendor, or if you are
unable to reach your vendor, contact Spotwave Wireless at 1-877-610-
9586.
Important Safety Information
Warning! For your safety, beware of power lines and ensure appropriate
safety measures are maintained at all times during the installation of the
SpotCell equipment. If equipment not shipped with the SpotCell system
is to be used during installation or mounting, follow all equipment
manufacture’s instructions in proper use to ensure injury is avoided.
The DU and CU of the SpotCell are low power transmitters. As with a
cell phone antenna, avoid unneccessary contact with the front of the
units after installed. Mount the units in a location where people will not
approach within 1 meter of the front of the DU and 20 centimeters in
front of the CU.
The Spotcell 111/112 CU is provisioned with an MCX connector at the
back for extended coverage area. This allows customers to extend the
coverage area by connecting the RF output to an external antenna
through an RG-6 cable. SpotWave Wireless Inc recommends that the
maximum antenna gain of the external antenna not exceed 3dBi and
that the two antenna be separated by at least 2 meters.
The minimum distance for Maximum Permissible Exposure (MPE) to
RF signals from the external antenna is less than 1 cm for both the
general public and occupational personnels when using an antenna with