User's Manual
Table Of Contents
- 1 – Introduction
- 2 – Getting Started
- 3 – Installation
- 4 – Mounting
- 5 – Displayed Information
- 6 – Trouble Shooting Information
- Appendix A – Applications overview
- Appendix B – System Specifications
- Appendix C – Safety Hints
M
OUNTING
22
SpotCell 100, Release 1.0
4.5 Mounting the SCU
The SCU has a bracket attached as illustrated below. The bracket can be
rotated to allow mounting to a ceiling or wall such that the face of the
unit is parallel to the floor or ceiling, or positioned at approximately 45
degrees.
Figure 4.9: SCU mounting bracket.
Mounting the SCU
1.
Find a suitable location to mount the unit that will provide good
signal coverage.
2.
If mounting on a solid wood surface, or stud covered by drywall,
drill a 1/8th inch diameter hole and mount with #6 x 1.5” screws.
or
If mounting in drywall, drill a ¼ inch diameter hole, insert the
nylon screw anchor, and then mount with a 1/2” pan head screw.
3.
Attach cables to the wall using tie wraps and mount directly to the
wall where possible (using 1/2 inch pan head screws). If an anchor is
required drill a 3/16 inch diameter hole, insert the anchor, and
fasten with 1/2 inch screws.
SCU bracket