User's Manual

I
NSTALLATION
8
SpotCell 100, Release 1.0
2.
Connect the DDU and SCU with the enclosed RF cable.
Note: The SCU does not have to be in its final location while
positioning the DDU. During DDU installation, it is usually
helpful to have the SCU near the DDU.
3.
Connect the power supply wires to the SCU by holding down the
blue tab and pushing the positive wire (marked with text) into the
positive (+) side of the connector. While still holding down the blue
tab push the remaining negative wire (identified by no text) into the
negative (-) side of the connector. Release the tab to secure the
power supply wires.
Figure 3.1:Inserting wires in SCU to supply power
4.
Plug the power supply adapter into a wall socket
5.
Ensure the switch on the SCU is in the ‘Install’ position.
Insert wires
here
Depress
tab here
TO BE UPDATED