User's Manual
Table Of Contents
- SmartOne C Basics
- Getting Started
- SmartOne Configuration Software Overview
- User Data Entry Pane
- Standard Messaging - Without Motion
- Standard Messaging Mode - With Motion
- Reduced Messaging Mode
- Theft Alert Mode
- Continuous GPS Mode
- Messages
- Type 1 Message Class
- Type 2 Message Class
- Messaging Priority
- Serial Commands
- Connecting Serial Devices to the SmartOne
- Appendix A - Glossary of Terms
- Appendix B - Technical Support
- Appendix C - RF Radiation Exposure Statement
- Appendix D - Regulatory Notices
- Appendix E – General Warnings
- Appendix F – Specifications & Standards
- Appendix G – Latitude/Longitude Decoding
- Appendix H – Standard Message Decoding
- Appendix I - Diagnostic Message Decoding
- Appendix J - Accumulate/Count Message Decoding
- Appendix K - External Input Cables
- Appendix L – Battery Life Estimate
Page 26SmartOne C User Manual Confidential & Proprietary Information
9100-0410-01 R2.4
TIME(S) OF DAY MESSAGING
When selecting Time(s) of Day from Interval Messaging, the following informational warning message will be
displayed:
The SmartOne can be configured to report at specific time(s) of day. The message interval box allows up to 12 times
of day to send Location Messages. The minimal interval between Time of Day settings is 35 minutes. Initially, there
will be no Time(s) of Day entered in the message interval box. Create a Time of Day interval by selecting Hours and/
or Minutes then:
• Click the ADD button to accept the interval and add it to the message interval box.
• Click the REMOVE button to delete the selected time of day from the message interval box.
• Click the CLEAR button to delete all the time of day(s) in the message interval box.