User's Manual
Table Of Contents
- SmartOne C Basics
- Getting Started
- SmartOne Configuration Software Overview
- User Data Entry Pane
- Standard Messaging - Without Motion
- Standard Messaging Mode - With Motion
- Reduced Messaging Mode
- Theft Alert Mode
- Continuous GPS Mode
- Messages
- Type 1 Message Class
- Type 2 Message Class
- Messaging Priority
- Serial Commands
- Connecting Serial Devices to the SmartOne
- Appendix A - Glossary of Terms
- Appendix B - Technical Support
- Appendix C - RF Radiation Exposure Statement
- Appendix D - Regulatory Notices
- Appendix E – General Warnings
- Appendix F – Specifications & Standards
- Appendix G – Latitude/Longitude Decoding
- Appendix H – Standard Message Decoding
- Appendix I - Diagnostic Message Decoding
- Appendix J - Accumulate/Count Message Decoding
- Appendix K - External Input Cables
- Appendix L – Battery Life Estimate
Page 13SmartOne C User Manual Confidential & Proprietary Information
9100-0410-01 R2.4
TOOLS MENU
NOTE: To effectively use the SmartOne Software Tools’ testing and diagnostic features, connect to the SmartOne
device while it has a good view of the sky to successfully transmit over the satellite network.
• SmartOne Testing - This command opens a window with the following options:
• SMARTONE(s) - Displays a drop-down list of connected SmartOne units
listed by ESN.
• Send Location Message Button - Causes the SmartOne connected to the
COM port to obtain a GPS fix and send a Location Message.
• Send Diagnostic Message Button - Causes the SmartOne connected to send
diagnostic information including battery status, GPS average search time,
GPS fails and number of transmissions since last diagnostic message.
• Send Truncated Message Button - Causes the SmartOne to seek a GPS
location, and then send a Truncated SmartOne message (type 1). The hex-
character data in the text box below the command will be appended to the
GPS data and sent.
• Send Raw Message Button - Causes the SmartOne to send the first 8 bytes
of data in the text box below the command as the payload for the Raw
Payload Message (type 2). The hex-character data in the text box below the
command will be sent instead of the normal SmartOne position data.
• Close Button - Causes the pop-up window to close.