REMOTE SYSTEM INSTALLATION INSTRUCTION GUIDE WARNINGS, DIRECT & ANCHOR BOLT, CONCRETE & STEEL POLES, EQUIPMENT ASSEMBLY
REMOTE SYSTEM INSTALLATION See warnings on carton Installation Instructions Read all of the following instructions prior to installation and formulate an action plan for installation of your SLS system. Different foundation/pole/crossarm combinations require their own unique plan. Ensure that these instructions are available for future servicing of this installation. WARNING! • Disconnect power before installation or servicing. • Install, operate and maintain to meet all applicable codes.
REMOTE SYSTEM INSTALLATION Poles (concrete and steel) • When unloading poles from freight carrier: • Verify that all required materials have been received. • Check all poles or pole sections for possible damage incurred during shipping. • Use proper pick-up points and equipment for lifting poles or pole sections to prevent damage. • Match pole ID mark with that described on the lighting layout provided by Hubbell Lighting Applications Engineering and unload at these locations on the job site.
REMOTE SYSTEM INSTALLATION Direct Embedded Foundation Design Sample (Fig. 1) Pole Elevations (Fig. 3) (This is a samply only, your SLS installation will require it’s own design) CROSSARM ASSEMBLY MOUNTING ELEVATION 3’ TYPICAL LAYOUTS ARE 4 OR 6 POLES PER FIELD. VARIOUS POLE LOCATIONS SHOWN. 45° TYP. VEWING POINT 90° TYP. CROSSARM ASSEMBLY SURFACE X X POLE. HANDHOLE AND REMOTE HEADS TO BE ON PLAYING FIELD SIDE (TYP.
REMOTE SYSTEM INSTALLATION Alignment Details (Fig. 5) Alignment Details (Fig. 4) poles are plumb in all CORRECT ALIGNMENT ROTATE Notes: Insure that all directions. All poles have taper as noted INCORRECT ALIGNMENT above.
REMOTE SYSTEM INSTALLATION Component Component MatchingMatching (Fig. 7) (Fig. 7) (Layout is for example only) (Layout shown is forshown example only) CROSSARM CROSSARM ASSEMBLYASSEMBLY BOX JUNCTIONJUNCTION BOX (CONCRETE POLE OR WOOD (CONCRETE POLE OR WOOD POLE ADAPTION ONLY) POLE ADAPTION ONLY) REFLECTORS REFLECTORS MATCH CAT. NO. OF EACH MATCH CAT. NO.
REMOTE SYSTEM INSTALLATION Standard Remote Layouts Front View TWO ROW CROSSARM ASSY. (Fig. 8) ONE ROW CROSSARM ASSY. (Fig. 8) (QUANTITY OF FIXTURES SHOWN IS FOR EXAMPLE ONLY) (QUANTITY OF FIXTURES SHOWN IS FOR EXAMPLE ONLY) FIXTURE POSITION NUMBERS 6 4 2 1 3 ROW IDENTIFICAITON T = TOP ROW M = MIDDLE ROW B = BOTTOM ROW 5 T T B REMOTE BALLAST BOX FIXTURE POSITION #’s BALLAST 3 4 5 6 1 2 TOP ROW BOTTOM ROW REMOTE BALLAST BOX PLUG WIRING ASSIGNMENTS (Fig. 8) THREE ROW CROSSARM ASSY (Fig.
REMOTE SYSTEM INSTALLATION INSTRUCTIONS FOR CLAMP-ON COMPONENT MOUNTING TO CONCRETE POLES (FIG. 10) TRUCTIONS FOR CLAMP-ON COMPONENT MOUNTING TO CONCRETE POLES (FIG. 10) TOP VIEW OF JUNCTION BOX TOP VIEW OF JUNCTION BOX SECURE JUNCTION BOX TO CROSSARM ASSY. WITH ¼” O BOLTS (2),BOX WASHERS & NUTS SECURE JUNCTION TO SHIPPED BOX CROSSARM ASSY.
REMOTE SYSTEM INSTALLATION CAP CAP PLATE PLATE COMPONENT COMPONENT MOUNTING MOUNTING TO TO STEEL STEEL OR OR CONCRETE CONCRETE POLES POLES (FIG. (FIG.
REMOTE SYSTEM INSTALLATION ANCHOR BOLT DETAIL (FIG. 13) ANCHOR BOLT HEX NUT LOCK WASHER FLAT WASHER BOLT PROJECTION POLE BASE PLATE CONCRETE FOUNDATION SLS ANCHOR BOLT ALIGNMENT DETAILS (Fig.
