Installation Guide

www.sportdogbrand.com 11
The Collar Receiver has
to be held on top of the
Boundary Wire to activate.
• Replace battery.
• Adjust Range Adjuster knob clockwise to
increase the distance from the Boundary
Wire that the Collar Receiver activates.
• Adjust the Boundary Control Switch to the
other setting.
• If using a Double Loop, make sure Boundary
Wires are separated 3 to 5 feet.
• If the Collar Receiver still has to be held
on top of the Boundary Wire, perform the
“Short Loop Test.”
The Collar Receiver
activates inside the house.
• Turn the Range Adjuster knob
counterclockwise to decrease the distance
from the Boundary Wire that the Collar
Receiver activates.
• Make sure the Boundary Wire is not running
too close to the house. The signal can
transmit through the walls of your house.
• Make sure Boundary Wires are twisted from
Boundary to the Fence Transmitter.