Use And Care Manual

8 1-800-732-0144
WWW.SPORTDOG.COM 9
STEP
::
03STEP
::
04
matCH tHe remote Beeper
To match the Remote Beeper to work with a new Remote Transmitter or to reprogram a
new Remote Beeper to work with your existing Remote Transmitter (SD-1875, SD-1825,
SD-1825CAMO, SD-2525):
A. Check to make sure the Remote Beeper is off.
B. Press and hold the On/Off Button. The Remote Beeper Indicator Light will come
on, then turn off after 4-5 seconds. If the On/Off Button is released too early, the
Remote Beeper Indicator Light will begin flashing as normal. If this occurs, start over
from A.
C. After the Remote Beeper Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Remote Beeper
Indicator Light flashes 5 times. Once the Remote Beeper Indicator Light has flashed 5 times,
the Remote Beeper has been matched and will begin flashing as normal. If the Remote
Beeper Indicator Light does not flash 5 times, start over from A.
NOTE: For more information on programming modes, please consult the original Operating
Guide that came with your SD-1875, SD-1825, SD-1825CAMO or SD-2525 system; or visit our
website to download a manual at www.sportdog.com.
manUaLLy ConfIGUre remote Beeper
SET TONE AND RUN MODE
While the Remote Beeper can be remotely programmed from the Remote Transmitter, you can
also set tone and run mode from the beeper itself.
1. Turn the Remote Beeper off.
2. Press and release the On/Off button to turn on the Remote Beeper.
3. Within 5 seconds press and hold the On/Off button. The Remote Beeper will begin to cycle
through available tones found on the following page.
MODE TONE
1 High Volume Beep
2 Double High Beep
3 High Falling To Low Volume Beep
4 Double High Falling To Low Volume Beep
5 Low Volume Hawk
6 High Volume Hawk
7 Bob White Quail Call
8 Triple Beep
9 Low Volume Beep
4. When the desired tone is heard, release the button before the next tone starts. Tone is now
set.
5. Press and hold the button immediately following tone selection completion until the number of
beeps matches the desired run mode as shown in the chart below.
1 Beep (Silent)
No beep when dog is running/Beeps once per second when
dog is on point
2 Beeps (5 second)
Beeps every 5 seconds when dog is running/Beeps once per
second when dog is on point
3 Beeps (10 second)
Beeps every 10 seconds when dog is running/Beeps once per
second when dog is on point
6. Release the button after the corresponding number of beeps matches your desired run
mode.
LOCATING YOUR DOG IN THE FIELD USING A REMOTE TRANSMITTER
Anytime your dog is within one mile (two miles if using SD-2525 Remote Transmitter),
you can make the Remote Beeper beep by pressing the Locate Button on the Remote
Transmitter. The Remote Beeper will beep once each time you press the button.
Pressing the Locate Button disables the Remote Beeper’s run mode, but it is still
on. To reactivate the run mode, press and release the UplandHunter
®
1875 Remote
Transmitter’s Run Mode button. To reactivate the run mode on SD-1825, SD-1825CAMO or
SD-2525 models, press and hold the Remote Transmitter’s Locate Button. The Remote Beeper
will emit 3 beeps to confirm run mode has been activated and will continue operating in the
last run mode in which it was set.