OPERATING GUIDE PLEASE READ THIS ENTIRE GUIDE BEFORE BEGINNING
Important Safety Information Explanation of Attention Words and Symbols used in this guide _____________________________________________________________ This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. Thank you for choosing SportDOG Brand.® Used properly, this product will help you track your dog efficiently and safely.
ON/OFF BUTTON Beeper CHARGING JACK BEEPER INDICATOR LIGHT STEP :: 01 KEY DEFINITIONS REMOTE BEEPER PREPARE THE REMOTE BEEPER CHARGE THE REMOTE BEEPER 1. Lift the rubber cover protecting the Charging Jack. 2. Connect accessory cable to cradle and Remote Beeper. 3. Plug the charger into a standard 120/240-volt AC wall outlet. 4. Charge the Remote Beeper for 2 hours for the first charge and every charge thereafter. Using Li-Ion technology, the Remote Beeper only requires a 2 hour charge.
REMOTE BEEPER FUNCTION LIGHT COLOR LIGHT FUNCTION Unit is on Green Unit is on Red Unit is turned on via On/Off Button Green Unit is turned off via On/Off Button Red Unit is charging Unit is fully charged Green Green Light flashes every 3 seconds Light flashes every 3 seconds Light is solid in color during beep sequence Light is solid in color during beep sequence Light is solid in color Light flashes every second BATTERY STATUS Good Low N/A N/A N/A N/A RECHARGEABLE BATTERIES STEP :: 02 REMOT
STEP :: 03 MATCH THE REMOTE BEEPER To match the Remote Beeper to work with a new Remote Transmitter or to reprogram a new Remote Beeper to work with your existing Remote Transmitter (SD-1875, SD-1825, SD-1825CAMO, SD-2525): A. Check to make sure the Remote Beeper is off. B. Press and hold the On/Off Button. The Remote Beeper Indicator Light will come on, then turn off after 4-5 seconds. If the On/Off Button is released too early, the Remote Beeper Indicator Light will begin flashing as normal.
ACCESSORIES To purchase additional accessories for your SportDOG Brand® UplandHunter ® Add-A-Beeper®, contact the Customer Care Center at 1-800-732-0144 or visit our website at www.sportdog.com to locate a retailer near you.
TERMS OF USE AND LIMITATION OF LIABILITY TROUBLESHOOTING The answers to these questions should help you solve any problem you have with this system. If they do not, please contact the Customer Care Center at 1-800-732-0144 or visit our website at www.sportdog.com. • Check to see if the Remote Beeper has been turned on and the Indicator Light is flashing. • Refer to “Manually Configure Remote Beeper.
BATTERY DISPOSAL FCC COMPLIANCE This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Collar Receiver/Remote Beeper UPLANDHUNTER® SDR::AB ADD-A-DOG® UPLANDHUNTER® SD::BEEP REMOTE BEEPER NOTE: SDR-FS, SDR-FH, SDR, SDR-CH, SDR-FC, SDR-BEEP AND SDR-H ADD-A-DOG COLLARS ARE NOT COMPATIBLE WITH THIS SYSTEM. SDR-A, SDR-AW AND SDR-AH ADD-A-DOG COLLARS ARE COMPATIBLE WITH THIS SYSTEM.
