Installation Guide

14 1-800-732-0144
WWW.SPORTDOG.COM 15
matCH tHe CoLLar reCeIVer anD remote tranSmItter
To match the Collar Receiver to work with a new Remote Transmitter or to match a new Collar
ReceivertoworkwithyourexistingRemoteTransmitter:
A.TurntheCollarReceiveroff.
B.PressandholdtheOn/OffButton.TheReceiverIndicatorLightwillcomeon,thenturnoffafter4-5
 seconds.IftheOn/OffButtonisreleasedtooearly,theReceiverIndicatorLightwillbeginashingas
 normal.Ifthisoccurs,startoverfromA.
C.AftertheReceiverIndicatorLighthasturnedoff,releasetheOn/OffButton.
D.Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light
 ashes5times.OncetheReceiverIndicatorLighthasashed5times,theCollarReceiverhasbeen
 matchedandwillbeginashingasnormal.IftheReceiverIndicatorLightdoesnotash5times,
 startoverfromA.
proGram tHe SyStem for tWo or tHree-DoG operatIon
SportDOG
™
Add-A-Dog
®
CollarReceiver(s)mustbepurchasedtotrainadditionaldogs.
Please refer to the back cover for compatible Add-A-Dog Collar Receivers for this system.
1.ProgramtheRemoteTransmittertomode3or4(seepage13).
2.ProgramtherstCollarReceiver.
 A. TurntheCollarReceiveroff.
 B. PressandholdtheOn/OffButton.TheReceiverIndicatorLightwillcomeon,thenturnoff
 after4-5seconds.IftheOn/OffButtonisreleasedtooearly,theReceiverIndicatorLightwill
  beginitsnormalashing.Ifthisoccurs,startoverfromA.
 C. AftertheReceiverIndicatorLighthasturnedoff,releasetheOn/OffButton.
 D. PressandholdtheUpper ButtonontheRemoteTransmitteruntiltheReceiverIndicatorLight
  ashes5times.IftheReceiverIndicatorLightdoesnotash5times,startoverfromA.
3.Program the second Collar Receiver using A through D above, but using the Lower Button in
 placeoftheUpperButton.
4.ProgramthethirdCollarReceiverusingAthroughDabove,butusingtheSide Buttoninplaceof
 theUpperButton.
CHanGe ID CoDeS
AnID Codeis thesignalidentication betweenthe RemoteTransmitter andCollar Receiver.Each
isprogrammed in 1of 2,000 IDCodes from thefactory.TheSportHunter
®
825 has theexibility to
programtwoormoreRemoteTransmitterstothesameIDCode,allowingthemtocontroloneCollar
Receiver.Thereare64programmableIDCodesavailable.
TO MANUALLY PROGRAM A REMOTE TRANSMITTER’S ID CODE FOLLOW THESE STEPS:
1.TurntheIntensityDial toV/T,and thenpressand releasetheModeButton onthebackof your
 RemoteTransmitter.Thisdoesnotchangethemode,sothecurrentmodewillstillbeactive
 aftertheIDchangeiscomplete.
2. OncetheModeButtonisreleased,theTransmitterIndicatorLightwillilluminatesolidgreenand
 stayonfor15seconds.
3. WhilethegreenIndicatorLightison,turntheIntensityDialtoselectthe1stdigitoftheIDandthen
 pressandreleasetheSideButton.ThegreenIndicatorLightwillashrapidlyconrmingselection.
STEP
::
06STEP
::
07STEP
::
08
4.Again,whilethegreenIndicatorLightison,turntheIntensityDialtoselectthe2nddigitoftheIDandthen
 pressandreleasetheSideButton.ThegreenIndicatorLightwillashrapidlyconrmingselection.The
 2nddigitisoptionaland,ifnotdesired,waituntilthegreenlightturnsoffandrefrainfrompressing
 theSideButton.
5.Attheendof15seconds,orafterthesecondpressoftheSideButton,thegreenIndicatorLightwillturnoff
 andtheIDoftheunitwillbeupdated.Atthispoint,theunitwillbeinthesamemodeitwasinprior
 tosettingtheID.
6.UponchangingtheIDCode,youwillneedtomatchtheCollarReceivertotheRemoteTransmitter
 (seeSTEP6onpage14).
TO RETURN THE UNIT TO THE FACTORY ID FOLLOW THESE STEPS:
1.TurntheIntensityDialtoV/T,andthenpressandreleasetheModeButtononthebackofyour
RemoteTransmitter.Thisdoesnotchangethemode,sothecurrentmodewillstillbeactiveafter
 theIDchangeiscomplete.
2. DonotpressanybuttonsandwaituntilthegreenTransmitterIndicatorLightturnsoff.
3. YouwillneedtomatchtheCollarReceivertotheRemoteTransmitter(seeSTEP6onpage14).
aCCeSSorIeS
To purchase additional accessories for your SportDOG Brand
®
SportHunter
®
825, contact the Customer Care
Centerat1-800-732-0144orvisitourwebsiteatwww.sportdog.comtolocatearetailernearyou.
Component Part Number
3
⁄4”BlackCollarStrap SAC00-10816
3
⁄4”BlazeOrangeCollarStrap SAC00-10815
3
⁄4”BlueCollarStrap SAC00-11921
3
⁄4”GreenCollarStrap SAC00-10817
3
⁄4”RedCollarStrap SAC00-11820
3
⁄4”WhiteCollarStrap SAC00-12796
3
⁄4”YellowCollarStrap SAC00-12795
CollarReceiver(doesnotincludecollarstrap) SDT[phone]
RemoteTransmitterOnly SDT[phone]
RemoteTransmitterwithLanyard,AntennaandBeltClip SDT[phone]
Antenna SAC00-12543
ContactPoints(Short) SAC00-12571
ContactPoints(Long) SAC00-12570
BatteryKit(CollarReceiver) SAC54-13735
BatteryKit(RemoteTransmitter) SAC54-13924
WallCharger SAC00-13736
AccessoryPack(includesscrewsandChargingJackcovers) SAC00-14008