Installation Guide

8 1-800-732-0144

PREPARE THE COLLAR RECEIVER

TO TURN THE COLLAR RECEIVER ON

TO TURN THE COLLAR RECEIVER OFF

1. Press and hold the On/Oﬀ Button until the Receiver Indicator Light comes on and the

Collar Receiver beeps 2 times.

2. Release the On/Oﬀ Button.

NOTE: Maximum battery life is one month. If the Collar Receiver is left on

continuously, the maximum battery life will be 1-2 weeks. To extend the battery

life, turn the Collar Receiver oﬀ when it is not in use.

RECEIVER INDICATOR LIGHT

INSERTING 3-VOLT BATTERIES

1. Use a small Phillips screwdriver to remove the

two screws on the Collar Receiver.

2. Remove the battery door.

3. Insert two (CR2032) 3-volt lithium batteries

(positive side up) per the diagram found on the

Collar Receiver.

4. Replace the battery door. To ensure

waterproofness, check that the o-ring is in place

and clean. Press and snap into the Collar Receiver.

5. Tighten the screws, being careful not to

overtighten.

1. Press and hold the On/Oﬀ Button until the

Receiver Indicator Light comes on and the

Collar Receiver beeps 5 times.

2. Release the On/Oﬀ Button.

The Receiver Indicator Light will ﬂ ash until the

Collar Receiver is turned oﬀ . The ﬂ ashing light

indicates the Collar Receiver is ready to receive

a radio signal from the Remote Transmitter.

STEP

COLLAR RECEIVER FUNCTION INDICATOR LIGHT RESPONSE

Collar Receiver on - good battery Flashes once per second

Continuous static stimulation button pressed Solid in color

Tone button pressed No response

ON/OFF

BUTTON

O-RING