Installation Guide

WWW.SPORTDOG.COM 11
MATCH THE COLLAR RECEIVER AND REMOTE
TRANSMITTER
To match the Collar Receiver to work with a new Remote Transmitter or to match a new Collar Receiver to
work with your existing Remote Transmitter:
A. Turn the Collar Receiver off .
B. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off
after 4-5 seconds. If the On/Off Button is released too early, the Receiver Indicator Light will
begin fl ashing as normal. If this occurs, start over from A.
C. After the Receiver Indicator Light has turned off , release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light
fl ashes 5 times. Once the Receiver Indicator Light has fl ashed 5 times, the Collar Receiver has
been matched and will begin fl ashing as normal. If the Receiver Indicator Light does not fl ash
5 times, start over from A.
ACCESSORIES
To purchase additional accessories for your SportDOG Brand
®
YardTrainer 105S, contact the
Customer Care Center at 1-800-732-0144.
Component Part Number
Remote Transmitter
SDT[phone]
Collar Receiver SDT[phone]
(2) 3-volt CR2032 Batteries RFA-35-11
Lanyard SAC00-12799
Accessory Pack (includes Contact Points,
washers, Collar Receiver battery door, and
o-rings/screws for battery door)
RFA-39
STEP
::
05