Installation Guide

8 1-800-732-0144
STEP :: 02
OPERATE THE BARK CONTROL COLLAR
TURNING THE UNIT ON/OFF
Press and release the power button (located between the Contact Points) for about one second - the unit will power
on immediately, as well as tone. To turn the unit off, press and hold the power button for three seconds. A tone will
sound, then the unit will turn off.
NOTE: If the user does not press any button, the display will go blank after 15 seconds. To wake up the display, press
and release any of the buttons.
CHANGING THE MODES
The SBC-R has three modes of operation. These three modes are indicated by icons shown on the OLED display. The
following table summarizes the modes and their corresponding icons:
After changing modes, pressing and releasing the power button again while the mode is blinking will allow you to
change the static stimulation levels if you are in User-Selected or Temperament Learning modes. Pressing the
plus or minus buttons will cycle through the static stimulation levels. Temperament Learning static stimulation
levels can only be reset to level one by pressing the minus button, or reset to the last “learned” level by pressing the
plus button.
Plus and minus buttons have no function when displaying Progressive Correction mode as it always starts at
level one.
NOTE: In User-Selected mode, always start training at the lowest level of correction. Watch how your dog reacts,
and if necessary, increase to the next correction level.
PROGRESSIVE CORRECTION USERSELECTEDTEMPERAMENT LEARNING
POWER
BUTTON
PLUS/
MINUS
BUTTONS
MODE
DISPLAY
When the display is active (on) press and release
the power button. The mode icon will flash,
indicating that you can change modes. Press the
plus and minus buttons until the desired mode is
selected.