User Manual

6
Volume 2
Rear Panel
Mains Input
220-240V
~50Hz
Fuse: 200mA
110-120V
~60Hz
Fuse: 400 mA
AVIS: RISQUE DE CHOC ÉLECTRIQUE - NE PAS OUVRIR
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
Voltage Setting / Fuse Rating
Serial Number
Sound Performance Lab
Niederkrüchten, Germany
www.soundperformancelab.com
MADE IN GERMANY
TO REDUCE RISK OF FIRE OR ELECTRIC SHOCK DO
NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
DISCONNECT MAINS BEFORE REMOVING COVER.
THIS EQUIPMENT MUST BE EARTHED.
XLR WIRING WARNING
RIGHT InOut LEFT InOut
PIN CONFIGURATION OF XLR CONNECTIONS:
PIN 1 = GND, PIN 2 = (+) HOT, PIN 3 = (–) COLD.
ELECTRONICALLY BALANCED
INPUTS AND OUTPUTS (+4dB).
230V
1
2
3
Pin wiring XLR connectors
1=GND, 2=hot (+), 3=cold (-)
Power Supply, On/Off Switching
Be sure before connecting the Volume 2 to power that the rear-chassis
voltage supply is switched to the proper local rating (either 230 or 115 volts).
Above all, before connecting any machines, always take additional care to
power down all those to be used (and move the rear-chassis power supply
switch of the Volume 2 to the “down“ position).
Finally, always use the following procedure in powering up your assembly:
Always power on your Volume 2 first before the power amp or active
speakers. When powering down, always power off the power amp or active
speakers before your Volume 2. Not following this sequence can result in ear
or speaker damage from high level discharges!
The Volume 2 comes with a standardized 3-pole (grounded) IEC power cord
which is connected to the main power input socket (Mains Input). The trans-
former, cable and socket conform to VDE, UL, and CSA requirements. The
actual power ratings are 250mA at 230 volts and 500mA at 115 volts.
Balanced right and left XLR Inputs to provide for stereo source connections.
The nominal signal level is at +4 dB, other levels will be transmitted 1:1.
Balanced right and left XLR Outputs to provide for connections to power
amps or active speakers.