Installation Guide

X2
X2 X2
1 2 3 4
Loosen the screw
Open the back cover
Remove the
xture and moun
ng package from the box and make sure that no parts
are missing b
referencing the illustra
on on the installa
on instruc ons.
install the product. SAVE THESE INSTRUCTIONS IN A LOCATION CLOSE TO YOUR LIGHT
FIXTURE SO YOU CAN REFER TO THEM AT A LATER TIME.
WARNING
!
A B
C
CAUTION
Waterproof rubber
Screw
5
6
7
Tighten the screw to complete
C
Use the waterproof rubber (A) to
cover the back cover, then fix the
dual-head light to the back cover
A
Dual Head Motion Activated LED Security Light
DH-B10W-XXX
USE AND CARE GUIDE
Page 1 of 4 Page 2 of 4
www.evereadyledlighting.com
Toll-Free Number: 888-883-3266
[e-mail]
The product is not a toy and contains small parts, close supervision is necessary
when this unit is used near children. The remote control contains a button cell
battery. If swallowed, it could cause severe injury or death in just 2 hours, seek
medical attention immediately.
Do not mix old and new batteries. Do not mix alkaline, standard (carbon zinc) or
rechargeable batteries. Do not dispose of batteries in fire. Batteries may explode
or leak. Remove exhausted batteries from the product. Please dispose of
batteries properly.
DO NOT USE THIS FIXTURE WITH A DIMMING CIRCUIT.
If you currently have dimmer controls, you will need to remove them and replace
them with regular electrical switches.
If you have a three-way dimmer, you will have to replace it with a regular
three-way switch.
If you are unfamiliar with electrical installations, it is recommended you have a
qualified electrician do your installation.
2020
Mounting (wall or eave)
Battery Installation
Fix the back cover to the
surface with 2 screws (C)