User's Manual
Table Of Contents
- 1: Introduction
- 1.1 Documentation notes
- 1.2 Product introduction
- 1.3 General product handling and operation
- 1.3.1 Powering on/off and sleep mode
- 1.3.2 Attaching, detaching, and handling modules
- 1.3.3 Attaching the Wi-Fi antenna
- 1.3.4 Attaching the strap
- 1.3.5 About the touchscreen display
- 1.3.6 Selecting the active interface
- 1.3.7 Starting a function or test
- 1.3.8 Stopping a test
- 1.3.9 Saving results
- 1.3.10 Interpreting results
- 1.4 Maintenance
- 1.5 Technical support
- 2: Wi-Fi Testing Menu
- 3: 10/100 Testing Menu
- 4: System Menu
- 5: IP and Video Testing
- 5.1 IP Network Setup
- 5.2 Connection Information
- 5.3 Ping
- 5.4 Traceroute
- 5.5 Web Browser
- 5.6 IP Video testing
- 6: Specifications
Tech-X Flex™ Base Unit User Guide Issue 1
5: IP and Video Testing 5-9
Intro
Wi-Fi
10/100
System
IP/Video
Specs
Figure 5-4 Video QoS Setup - Page 1 (with channel guide)
Table 5-6 Video QoS test - Setup parameters
Parameter Description
Channel Num
Channel Abbr
If a channel guide was used, the channel number and abbreviation that was
selected in the previous screen. If no channel guide is active, these fields do not
appear. For more information on channel guides, see About channel guides on
page 4-7.
IP Address IP address of the video stream. If you selected a channel from the channel guide,
this field is automatically populated.
The IP address specified must reflect the destination IP address for video stream
packets; that is, the first address contained in the IP packet headers. For a
multicast stream, this will be a multicast IP address, not an IP address of a host
on the network under test. For a unicast stream, this must be the IP address of
the destination device on the network, such as an STB. For a discussion on
multicast packet addressing and transport versus unicast, see About IP multicast
on page 5-25.