User's Manual
Table Of Contents
- 1: Introduction
- 1.1 Documentation notes
- 1.2 Product introduction
- 1.3 General product handling and operation
- 1.3.1 Powering on/off and sleep mode
- 1.3.2 Attaching, detaching, and handling modules
- 1.3.3 Attaching the Wi-Fi antenna
- 1.3.4 Attaching the strap
- 1.3.5 About the touchscreen display
- 1.3.6 Selecting the active interface
- 1.3.7 Starting a function or test
- 1.3.8 Stopping a test
- 1.3.9 Saving results
- 1.3.10 Interpreting results
- 1.4 Maintenance
- 1.5 Technical support
- 2: Wi-Fi Testing Menu
- 3: 10/100 Testing Menu
- 4: System Menu
- 5: IP and Video Testing
- 5.1 IP Network Setup
- 5.2 Connection Information
- 5.3 Ping
- 5.4 Traceroute
- 5.5 Web Browser
- 5.6 IP Video testing
- 6: Specifications
Base Unit User Guide Issue 1 Tech-X Flex™
4-4 4: System Menu
Intro
Wi-Fi
10/100
System
IP/Video
Specs
4.4 Auto Sleep Mode
Select System > Auto Sleep Mode.
This function sets the maximum amount of idle time after which the unit automatically enters “sleep
mode” in order to save battery power. It does not apply when the unit is powered by an external source.
For more information on sleep mode, see Powering on/off and sleep mode on page 1-9.
4.5 Version Info
Select System > Version Info.
This function provides information about hardware and firmware versioning currently applicable to the
unit, including the attached module, if any. This information may be required when obtaining technical
support from Spirent. It may also be useful for verification before and/or after firmware upgrades.
Figure 4-3 Version Info
4.6 Battery Status
Select System > Battery Status.
This function provides detailed information about the battery and current charging conditions. For the
general user, the Estimated Remaining Capacity percentage may be the most useful.