User's Manual Part 1

Nomad User’s Manual Chapter 6 – Initiating a Test
Copyright © Spirent Communications, Inc. 2013 58
6 Initiating a Test
Once a task has been assigned to each Nomad test channel and task settings have been configured, a
test session may be initiated. To start a test:
 Click the Start Logging Session button on the Test Setup tab.
The Start Logging Session Wizard will appear. The following sections describe each step in the
Wizard.
6.1 Reviewing the Current Channel Configuration
On the first screen of the Start Logging Session Wizard:
 Confirm the Audio Configuration and Email Campaign Configuration settings for each
test channel.
 If any changes are required, press Cancel to exit the Wizard and return to the Test Setup
tab. Otherwise, click Next to proceed to the next screen.
Figure 6-1 - Reviewing the Current Channel Configuration
6.2 Device Setup
If device pairing was not completed for any Bluetooth channel when task settings were modified,
the pairing may be completed on the Bluetooth Module Device Control screen. This screen will
not appear if all test devices use the Analog audio interface.
 The options on this screen are identical to those in the task settings Bluetooth Connection
dialog. See Section 5.2.7 for instructions on pairing each Bluetooth device with the Spirent
ME hardware unit.
 Click Next when all Bluetooth devices have been paired.