User's Manual Part 2

Tech-X Flex User Guide - Firmware v06.50 Tech-X Flex
®
(NG2)
7-30
Intro
Overview
Wi-Fi
Ethernet
System
IP/Video
MoCA
RF
Specs
As an example, with the following setup, a Bit Rate value in the Node Stats screen would be colored
yellow if it were between 180 and 189 Mbps and red if it were any higher:
Figure 7-20 Thresholds screen
Download Thresholds
As an alternative to editing thresholds directly on the unit, you can download a thresholds file to set all
thresholds as a batch. This action completely overwrites all existing thresholds on the unit.
For more information on the parameters required for the FTP transaction, see FTP connection
parameters on page 2-59. The remainder of this section describes the required threshold file format.
A threshold file uses a simple CSV format with lines in the following format:
thld_name,from_value,to_value,enabled
For example:
Q. Test Init Delay
Q. Test Settle Delay
Intentional delays to insert into the MoCA Quick Test process, in order to
allow the network time to stabilize. These settings do not represent a range
and therefore the To column is not applicable. Also, for Q. Test Init Delay,
the option of Auto is provided. For more information, see About intentional
test delays (MoCA Quick Test) on page 7-26.
Include Admission
Errors
For the MoCA Quick Test, allows you to prevent threshold evaluations
from considering MoCA admission frame errors (by setting it to No).
Admission frame errors may be normal on a network and you may want to
use this setting to prevent them from causing failure indications during the
test.
Preliminary issue - Limited distribution only!