User's Manual Part 2

Tech-X Flex User Guide - Firmware v06.50 Tech-X Flex
®
(NG2)
6-8
Intro
Overview
Wi-Fi
Ethernet
System
IP/Video
MoCA
RF
Specs
Figure 6-4 L4 Performance Test - Setup
6.5.2 Results - L4 Performance Test
The following table describes the basic metrics produced by the test, noting the following behavior:
• If the test is set up to produce interval results, a full set of results is produced for each interval,
independently for each stream. Additionally, each interval produces a full set of results that reflects
the composite of all streams.
• At the end of the results, the test produces a similar of group of results that reflect the entire testing
period. These results are produced from the perspective of the sender and from the receiver, if
available. For example, a 2-stream test might produce the following rows:
– S1 - Whole-test averages/totals for stream 1, from the perspective of the sender interface.
– R1 - Whole-test averages/totals for stream 1, from the perspective of the receiver interface.
– S2 and R2 - Whole test results for stream 2.
– S_ALL and R_ALL - Whole test results for all streams combined.
Report Interval Interval at which to report interim results, in seconds. Specify 0 (zero) to
produce composite results at the end of the test only.
Direction Test direction; that is, the direction of traffic flow, either Upstream or
Downstream.
Omit Number of initial seconds to exclude from results calculations, normally
used to avoid the impact of the normal TCP slow start algorithm.
Parameter Description
Preliminary issue - Limited distribution only!