User's Manual Part 2

Tech-X Flex User Guide - Firmware v06.50 Tech-X Flex
®
(NG2)
7-6
Intro
Overview
Wi-Fi
Ethernet
System
IP/Video
MoCA
RF
Specs
Figure 7-2 Join MoCA network - Input parameters
Security
Password
Security information. If the network requires a password to join, enter that password
and set Security to Enabled. Otherwise, set Security to Disabled and disregard the
password.
Dependent upon licensing, the behavior of these fields may vary, such as:
• Some units may automatically disable security settings upon the selection of a
certain Frequency, under the assumption that target networks will not have related
security features enabled.
• Under Password, some units may provide the option of Auto, allowing the unit to
automatically attempt one or more preconfigured passwords. If your unit displays
this option, please contact a network administrator or Spirent for more information on
the password(s) that would be attempted.
Bridge (ECB)
mode
Enables or disables ECB bridge functionality. If you plan to do video testing, specify
Disabled. For more information, see About MoCA and 10/100/1G interface bridging
(ECB) on page 7-23.
NOTE: This feature will not function correctly if you have an active 10/100/1G
Admin Port established. For more information, see Admin Port on
page 5-5.
Preferred NC If set to Yes, causes the unit to attempt to assume the role of network coordinator (NC)
upon synchronization. Depending on network conditions and the behavior of other
nodes, the unit may not be successful or may lose the NC role at some point
afterwards.
Parameter Description
Preliminary issue - Limited distribution only!