User's Manual Part 2

Tech-X Flex User Guide - Firmware v06.50 Tech-X Flex
®
(NG2)
7-2
Intro
Overview
Wi-Fi
Ethernet
System
IP/Video
MoCA
RF
Specs
7.2 Overview of testing capabilities and setup
The MoCA module allows the unit to join a MoCA network on a specified channel. After joining the
network, the unit can perform functions such as:
• Retrieval of statistics about itself and other nodes on the network, including the bandwidth between
nodes.
• IP address assignment and basic connectivity tests such as ping and traceroute.
• Video testing, both by actively joining a multicast stream and by passively monitoring an existing
stream.
There are two basic physical setups for the unit:
• Single-ended - A single cable terminated at the unit, where the unit is intended to join the network
similar to any other node and perform stats retrieval and active testing functions (see Join MoCA
Network (Single-ended testing details) on page 7-4)
• Bridged - Two cables terminated at the unit, where the unit is “bridging” a MoCA connection and can
passively monitor traffic, as well as perform active testing in either direction (see Join MoCA Network
In-Line (Bridging and passive testing) on page 7-19)
7.2.1 Testing scenarios
The following table describes certain issues that a technician might encounter, along with suggestions for
how to use the unit for troubleshooting. Your use of the unit may vary according to field conditions and
applicable protocol.
Preliminary issue - Limited distribution only!