User's Manual Part 2
Tech-X Flex User Guide - Firmware v06.50 Tech-X Flex
®
(NG2)
6-4
Intro
Overview
Wi-Fi
Ethernet
System
IP/Video
MoCA
RF
Specs
Figure 6-1 Successful IP Network Setup
6.1.3 DHCP troubleshooting tips
If a DHCP operation fails, check the following:
• The unit is properly connected to an active, networked device. For example, when using the
10/100/1G interface, the Ethernet cable must be properly connected. Or, for the Wi-Fi interface, the
unit must be within range of an active wireless node.
• The target network has an active DHCP server. In a home network, the DHCP server is normally
incorporated with the home router, in which case you may need to log into the router to ensure that
the DHCP server has not been disabled. See the router documentation for more information.
6.2 Connection Info
This function reports the IP information that is currently assigned to the active interface and is identical to
the results screen from a successful IP Network Setup. For more information, see Results - IP Network
Setup on page 6-3.
6.3 Ping
IP Ping is a basic connectivity test that verifies whether a specific IP address can be reached. It sends a
set of ICMP echo requests to an IP address and reports whether replies are successfully received. The
request is sent via the active interface of the unit and requires that routable IP information is assigned to
that interface. For more information, see IP Network Setup on page 6-1.
Preliminary issue - Limited distribution only!