User's Manual Part 2

Tech-X Flex User Guide - Firmware v06.50 Tech-X Flex
®
(NG2)
6-22
Intro
Overview
Wi-Fi
Ethernet
System
IP/Video
MoCA
RF
Specs
a LAN host may receive an address that is not routable once a router is connected; however, testing
may still succeed.
Figure 6-16 All Devices Packet Loss - BHR IP parameters
• BHR Present - This mode assumes that a router is functioning normally on the LAN and no DHCP
server on the unit is required.
After these options are resolved, the remainder of testing follows the normal host detection and ping
testing stages. Note the following:
• When the Replacing BHR option is selected, the unit assumes that the IP information provided will
be used to configure the MoCA IP interface. For this reason, the IP Network Setup function is not a
prerequisite to launch the All Devices Packet Loss test, unlike most other IP-related tests. If it has
already been run, the unit will prompt you to drop the current IP configuration before proceeding with
the All Devices Packet Loss test.
•If the BHR Present option is chosen but IP Network Setup has not been run yet, a DHCP-based
address assignment will occur automatically.
• The concept of replacing the router only applies to the MoCA interface because the unit can connect
to all LAN devices via a single coax, by nature of the MoCA environment. For a 10/100/1G network,
the unit would require a separate port for each device.
6.11 IP Video testing
IP video testing support includes:
Preliminary issue - Limited distribution only!