User's Manual Part 2

Tech-X Flex User Guide - Firmware v06.50 Tech-X Flex

(NG2)

6-20

Intro

Overview

Wi-Fi

Ethernet

System

IP/Video

MoCA

Specs

Following host detection, some addresses may be automatically selected and some may not. You should

ensure that the selection(s) are correct for the test, as well as select the testing Duration that applies to

all target hosts.

NOTE: At this point, if device detection was the only original purpose, you can review the results and

safely cancel the packet loss portion of the test.

Figure 6-13 All Devices Packet Loss - Setup following the host detection phase

The duration may be selected from the list or entered manually, up to 60 seconds. Alternatively, you can

select Continuous for a test that runs until manually stopped.

6.10.2 Results - All Devices Packet Loss

The test sends ping packets to all hosts simultaneously and reports a running total of packets sent and

lost:

Preliminary issue - Limited distribution only!