User's Manual Part 2

Tech-X Flex User Guide - Firmware v06.50 Tech-X Flex

(NG2)

8-24

Intro

Overview

Wi-Fi

Ethernet

System

IP/Video

MoCA

Specs

• View/Edit Thresholds on page 8-24 - Allows you to view and edit individual thresholds on the unit

• Download Thresholds on page 8-25 - Allows you to set all thresholds as a batch by importing a

threshold settings file

View/Edit Thresholds

(Select System > System/Module Settings > MoCA-RF Module > RF > Thresholds > View/Edit

Thresholds)

The settings in the Thresholds screen control the following:

• The coloring of test results - Any individual result that violates its respective threshold is colored

red

• The overall pass/fail evaluation for a channel - For any channel tested, if any result threshold is

violated, the channel test is considered a failure overall

The Thresholds screen allows two independent set of thresholds to be configured, labeled “TV/STB”

and “ONT/Modem.” These labels are intended as a convenience for the common practice of maintaining

two different threshold sets for testing at the respective locations. However, you may specify any

applicable thresholds for either set and test with them at any location. For more information on specifying

the threshold set to use during testing, see Channel Sweep Test setup on page 8-2 and Single Channel

Test setup on page 8-4.

For out-of-band (OOB) channels, the unit supports thresholds for minimum and maximum power levels

only. For more information on OOB channels, see About out-of-band (OOB) channel support on

page 8-18.

Figure 8-19 Threshold screen

Preliminary issue - Limited distribution only!