User's Manual Part 2
Tech-X Flex
®
(NG2) Tech-X Flex User Guide - Firmware v06.50
8-11
Intro
Overview
Wi-Fi
Ethernet
System
IP/Video
MoCA
RF
Specs
• Purge - Removes all results from the previous script run and proceeds to the script page.
• Keep - Proceeds to the script page to run a new Close-Out Script and appends any new results to the
previous results set.
• Proceed to FTP - Skips the script testing functions and proceeds directly to the FTP page (see
Close-Out Script results management and transfer on page 8-12).
Note that similar options are presented when you exit the script.
Once the script is fully launched, the setup screen allows you to select the following:
Figure 8-8 Close-Out Script setup
When you click Start, the test runs according to the configured settings and displays a results screen
similar to the Channel Sweep test (see Channel Sweep Test results on page 8-3). At this point, you can:
Setting Description
Close-Out
Location
The room within the premises where the current iteration of testing
should occur. It is assumed that the unit has been physically
connected to a coaxial outlet within that location. Note that each
location will display the total number of outlets tested for that
location as testing progresses.
Outlet The outlet number, within the selected location. This field may be
useful if a room has multiple outlets which require testing. During
the testing process, the unit only permits a single test run at any
given outlet number for a specific room.
Preliminary issue - Limited distribution only!