User's Manual Part 2

Tech-X Flex
®
(NG2) Tech-X Flex User Guide - Firmware v06.50
8-3
Intro
Overview
Wi-Fi
Ethernet
System
IP/Video
MoCA
RF
Specs
8.2.2 Channel Sweep Test results
For the results, note the following:
• See Channel testing measurements/results on page 8-12 for detailed results descriptions.
• In the graphical view, the table at the bottom shows details for the selected channel only, identified by
a lighter color on the bar graphs. Use the left/right arrow keys to change the selection.
NOTE: The PASS/FAIL indication also applies to the selected channel only. See Channel testing
measurements/results on page 8-12 for more information on pass vs. fail.
• In the graphs and tables, any result that has violated a configured threshold is colored red. See
Thresholds on page 8-23 for more information.
• Results are presented only for channels to which the unit could successfully synchronize.
• All results for all channels are measured and calculated one time only. The test does not perform
repeated measurements like the Single Channel Test.
• Results for out-of-band (OOB) channels include power measurements only. For more information,
see About out-of-band (OOB) channel support on page 8-18.
•Use the F1 key (Table / Graph) to toggle between the graphical and general tabular views. The
tabular view shows signal power measurements only, for all tested channels.
• While in the graphical view, use the F2 key (Audio / Video) to toggle between audio and video signal
measurements.
•Use the Channel shortcut (F3) to launch the Single Channel Test (see Single Channel Test on
page 8-4).
Figure 8-3 Channel Sweep Test results, with the second channel selected
Preliminary issue - Limited distribution only!