User's Manual Part 1
Table Of Contents
- 1: Introduction
- 2: Product Overview
- 2.1 Introduction to the workflow interface
- 2.2 Product overview
- 2.3 General product handling and operation
- 2.3.1 Protection from water and dust ingress
- 2.3.2 Important battery charging note
- 2.3.3 Powering on/off
- 2.3.4 Attaching the strap
- 2.3.5 About the touchscreen display
- 2.3.6 Selecting the active interface
- 2.3.7 Running a function or test
- 2.3.8 Repeating a function or test
- 2.3.9 Screen title bar buttons/icons
- 2.3.10 Capturing a screen image (screenshot)
- 2.3.11 Stopping a test
- 2.3.12 Saving results
- 2.3.13 Maximum test duration for continuous tests
- 2.3.14 Interpreting results
- 2.4 Handling the MoCA/RF module
- 2.5 Remote control of the unit
- 2.6 Licensed feature details
- 2.7 Maintenance
- 2.8 FTP information
- 2.9 Technical support
- 3: Wi-Fi Testing Menu
- 4: 10/100/1G Testing Menu
- 5: System Menu
- 5.1 Record Manager
- 5.2 Admin Port
- 5.3 Set Date and Time
- 5.4 Version Info
- 5.5 Battery Status
- 5.6 Video
- 5.7 Cal Touchscreen
- 5.8 Licensed Options
- 5.9 Update Firmware
- 5.10 System/Module Settings
- 5.10.1 System/Module Settings > Base Unit
- 5.10.2 System/Module Settings > RF Video Module
- 5.10.3 System/Module Settings > ADSL/VDSL2 Module
- 5.10.4 System/Module Settings > Combined Module Default
- 5.10.5 System/Module Settings > MoCA Module
- 5.10.6 System/Module Settings > DOCSIS Module
- 5.10.7 System/Module Settings > CSM Module
- 5.10.8 System/Module Settings > MoCA-RF Module
- 5.10.9 System/Module Settings > Wi-Fi
- 5.11 Signature Capture
- 5.12 Language Selection
- 5.13 Help and Support
- 5.14 System Information
- 5.15 Wizard GUI
Tech-X Flex User Guide - Firmware v06.50 Tech-X Flex
®
(NG2)
2-52
Intro
Overview
Wi-Fi
Ethernet
System
IP/Video
MoCA
RF
Specs
1. On the mobile device, make sure that the Wi-Fi interface is enabled. Refer to the documentation of
the specific device for more information.
2. Launch Mocha Lite.
Figure 2-46 Mocha VNC Lite initial setup screen
3. Tap Edit in the initial setup screen.
4. In the Edit session screen, configure the following:
• VNC Server IP - Enter the IP address of the unit.
• Password - Enter a pound sign (#) to indicate that no password is required.
• Port - Specify the destination TCP port, typically either:
The default of 5900 when using local remote control over a LAN or an ad hoc Wi-Fi network, or
The port reported for External VNC Port in the Enable WAN Remote Control results, when
controlling the unit over the internet (see Remote site remote control (via the internet) setup on
page 2-46).
...and tap Ok.
Preliminary issue - Limited distribution only!